This viscosity cup is in accordance with the specification Determination of viscosity of coating materials and the practical requirement of mechanical construction. It is applicable to the determination of viscosity of a certain coating materials of which flow time determined by it is under 150S.
Specification:
Volume of Cup |
100ml |
Inside Diameter of Orifice |
Φ4mm |
Correct Coefficient |
(0.97--1.03 ) 25 o C±2 o C |
Weight |
2kg |
Range of measurment |
112-685cst |
Effjyx time(sec) |
25-150sec |
Zahn Viscosity Cup:
The Zahn Viscosity Cups produced by our company is in accordance with specification of ASTM D4212-93 "Standard Test Method for Viscosity of Coating Materials" and Application, and the practical requirement of mechanical construction. They are applied to determine viscosity of the Newtonian and near Newtonian fluids.
Main Technical Parameters:
1. Volume of Cup: 44ml
2. Number of Cups: 1 2 3 4 5
3. Inside Diameter of Orifice (mm): 2.0 2.7 3.8 4.3 5.3
4. Range of Measurement (cst): 5--60 20--250 100--800 200--1200 400--1800
5. Correct Coefficiency: (0.95--1.05) 25oC± 0.2oC
6. Efflux time(sec): 30-80 sec
ISO Viscosity cup:
Our ISO viscosity cup/ISO Flow Cups is conform to International Standard ISO 24321-19 Paints and Varnishes-Determination of flow time by use of Flow Cups(Fourth Edition) and National Stand GB/T 6754.3-86 determination of Flow Time of Coating Materials ISO flow cup and the practical requirement of mechanical construction They are applied to determine the flow time of Newtonian and near Newtonian fluids.
Main Technical Parameters:
1. Type of Cup: ISO-3 ISO-4 ISO-5 ISO-6
2. Range of Measurement (mm2/S): 7--40 35--135 100--300 220--685
3. Weight: 2.3kg
Density Cup:
Density Cup produced by our company is accordance with the specification of National Standard GB/T 6750-86 paints and Varnishes Determination of density and the practical requirement of mechanical construction. It is applicable to determine the density for various coatings, supplemental materials, oils and related materials.
Main Technical Parameters:
1. Cup Volume: 50ml/4oC 100ml/4oC (37ml when ordering)
2. Counter Weight: It has a hole in center that may be filled with lea particles to adjust the mass.
Hardness tester>>
Impact tester>>
Cross cutter>>
Pencil hardness tester>>
|